- #DIGITAL TO ANALOG AUDIO CONVERTER CDR KING MANUAL#
- #DIGITAL TO ANALOG AUDIO CONVERTER CDR KING UPGRADE#
- #DIGITAL TO ANALOG AUDIO CONVERTER CDR KING FULL#
That's not what happens, apparently, unless your PC application is sending a Dolby Digital signal itself (i.e. and encode it as a Dolby Digital signal to be decoded by our receivers. Ideally, what we'd all like is for the Audigy 2 cards to take all multi-channel material from games, etc. In fact, in my case, utilizing the Radio Shack 3.5mm-to-RCA converter caused the L/R channels to be reversed. Posted on Friday, Aug12:32 GMTI can echo Rich's experience with Doom 3.
#DIGITAL TO ANALOG AUDIO CONVERTER CDR KING FULL#
Anyways, it is still decoding the AC3 from the audigy, and outputting it as 3 discreet SPDIF channels.not passing the full AC3 signal to my receiver through the top pole (as per this picture: ) even though I am turning AC3 decoding off in the surround mixer. I reinstalled all of the creative drivers, uninstalled them, and reinstalled them, and even though I unchecked the AC3 decode and checked digital output only, it is still sending out a PCM signal over the 3 SPDIF connectors inside the digital port on my audigy 1 (I can tell because left front/right front are on the left channel of my stereo mini to RCA and rear left/rear right are on the right channel.and when I back the mini plug out a bit with the right channel hooked to my receiver, I can hear "center" come out of the sub on the surround mixer testing program). Posted on Thursday, Aug02:06 GMTGentlemen.I have the same exact problem as whatasound aying doom3 made me realize that I was only getting 2 channels of audio to my receiver.
#DIGITAL TO ANALOG AUDIO CONVERTER CDR KING MANUAL#
The recievers blue S-master pro light comes on also when playing DVD from the PC indicating it is recieving a raw signal.hope this helps, I was looking for ages and finally decided to look at the online Audigy manual that clearly shows the configuration for connectivity to external recievers I have an Audigy connected to my Sony STRDA5000ES reciever using the above solution, before I was using 5.1 direct (3 x 3.5mm stereo to 6 RCA) and the volume was very low, now it is digital (SPDIF) the volume is unbearably loud where before it was quiet.
#DIGITAL TO ANALOG AUDIO CONVERTER CDR KING UPGRADE#
You must select digital output only from your card options.also if you are using a DVD programme make sure you select SPDIF so your reciever decodes as opposed to the PC, this may require an upgrade with most DVD software players but is well worth it (if you have a good reciever to decode) The best way to connect this is by getting a 3.5mm MONO to coax converter then plugging a coax or RCA video cable (yellow) from the converter to the Coax input of any reciever (use the yellow not the white or red as coax should be no less than 75ohm for quality reasons). Posted on Saturday, J11:20 GMTThe Audigy/Audigy 2 or any creative SB with the digital output requires a MONO 3.5mm to coax cable (or RCA, same bit different name).
0 kommentar(er)
